Home Produtos LCD TFT Módulo de LCD TFT standard WF57DTIACDNGD

Model No. WF57DTIACDNGD

►Tamanho: 5,7 polegadas
►Resolução : 320 x 240 pontos
►Direção de exibição: 12H
►Interface : RGB
►Controlador integrado: Não
►Placa de controle: Opção
►Brilho (cd/m²) : 700
►Controlador integrado: Não
►Tela de Toque: Com painel de toque capacitivo (PCAP)
►O-Film : Opção

DRAWING

5.7"  Projected Capacitive Touch Panel TFT LCD Module - WF57DTIACDNGD

SPECIFICATIONS

Interface

Pin No. Symbol I/O Description
1~2 IF1~IF2 I Input data format control
3 POL O Polarity Signal connect to VCOM driving circuit.
4 RESET I Hardware reset.
5 SPENA I Chip select
6 SPCL I Serial Clock
7 SPDA I/O Serial Data
8 B0 I Blue Data bit (LSB)
9~14 B1~B6 I Blue Data bit
15 B7 I Blue Data bit(MSB)
16 G0 I Green Data bit(LSB)
17~22 G1~G6 I Green Data bit
23 G7 I Green Data bit(MSB)
24 R0 I Red Data bit(LSB)
25~30 R1~R6 I Red Data bit
31 R7 I Red Data bit(MSB)
32 Hsync I Horizontal synchronous signal
33 Vsync I Vertical synchronous signal
34 Data CLK I Dot data clock
35~36 AVDD I 4.5V~5.5V
37~38 Vcc I 3V~3.6V
39 NPC O NTSC/PAL mode Auto detection result H:NTSC/L:PAL
40~41 VGL I Gate off power
42 UD I Up/Down scan setting. H: Reverse scan / L: Normal scan
43 VGH I Gate on power
44 LRC I Shift direction of device internal shift register control.
45 GND I GROUND
46~47 VCOM I VCOM driving input
48 ENB I Data enable input. Normally pull low.
49~50 GND I GROUND
Note: I: input, O: output, P: Power

General Specifications

Item Dimension Unit
Size 5.7 inch
Dot Matrix 320 × RGB × 240 (TFT) dots
Module dimension 126.00(W) × 101.55(H) × 8.235(D) (MAX) mm
Active area 115.2 × 86.40 mm
Dot pitch 0.12 × 0.36 mm
LCD type TFT, Normally White, Transmissive
View Direction 12 o'clock
Gray Scale Inversion Direction 6 o'clock
Interface 24-bit RGB
Aspect Ratio 4:3
Backlight Type LED, Normally White
PCAP FW Version FT5426
PCAP Interface I2C
PCAP IC FN058A001_FT5426_V02_20180604_all.bin
Touch Panel Projected Capacitive Touch Panel (PCAP)
Surface Glare

Absolute Maximum Ratings

Item Symbol Min Typ Max Unit
Operating Temperature TOP -20 +70
Storage Temperature TST -30 +80

Electrical Characteristics

Item Symbol Condition Min Typ Max Unit
Supply Voltage For LCM VCC 3.0 3.3 3.6 V
Supply Voltage For CTP VDDT 2.8 3.3 V
Input High Volt. VIH 0.7 VCC VCC V
Input Low Volt. VIL 0 0.3 VCC V
LCD Driving Supply Voltage VGH x 1 Ta=25℃ - 15 - V x 3
VGL x 2 - -10 -
VcomH 2.5 - 5.5
VcomL -2.0 - 0
Supply Current For LCM IVCC VCC=3.3V 5 8 mA
go top
close